This article will help you if you encounter any of the following issues:
- Your ScanWatch 2 is in Demo Mode
- Your ScanWatch 2 cycles through different screens on its own
If you encounter either of the issues mentioned above, try to perform a factory reset. To do so, perform the following steps:
- Open the Withings App and select Devices.
- Select the ScanWatch 2 from the device list, scroll down and then select Dissociate this product.
- Go to the Settings of your mobile device, select Bluetooth and locate ScanWatch 2 XX in the list of devices. Select the small icon to the right and select the option to Forget the device.
- Press and hold the button on the side of the watch for 5 seconds. Depending on how your watch was configured, ECG, SpO2, or Workout mode will start after pressing the button for about one second, but continue pressing until a menu appears on the watch's display.
- When on this menu, press the watch button until the screen shows Factory Reset.
- While the watch shows Factory Reset, press and hold the watch button for one second and you will see Reset in 5 clicks.
- Press the button 5 times and the watch will be reset to factory settings. While this occurs, the word Reset will appear on the watch’s display.
- The watch will now restart and show Hello! on its display. Please note that if the watch does not show Hello!, this means that the factory reset was not successful and so it must be performed again.
- You can now reconfigure the watch. Click here if you want to install your ScanWatch 2 again.