ScanWatch Light battery life
ScanWatch Light is equipped with a battery that goes well beyond the expectations of people who are familiar with the world of connected watches. Learn more about how you can optimize its performance.
Although ScanWatch Light is crafted to run for 30 days before needing to recharge, battery life is affected by use, and below we give an example of a typical 30-day-use scenario.
· 5000 steps per day
· 30 minutes of physical activity per week with Workout Mode enabled and the "Screen Always On" option disabled or when ScanWatch Light detects running. Note that use of connected GPS does not affect battery life.
· 8 hours of sleep a day
· Respiratory Scan off
· Live heart rate check once a day
· Connection to smartphone 12 hours a day in Bluetooth®
· 5 notifications a day
· Quicklook feature off
· No alarms set
· Automatic screen brightness adjustment off
· Up to 5 minutes per day of total on-screen time
Expected battery life may be affected by use, especially if your ScanWatch Light is used in a different manner than outlined above. Also be aware that signal and network quality, your smartphone model, or various environmental factors may also reduce expected battery life.
ScanWatch Light energy consumption
In order to better understand the energy consumption each feature uses, the table below will allow you to identify which operation is more or less draining on the battery.
|Low power consumption||Medium power consumption||High power consumption||Very high power consumption|
|- Pedometer (calculation of the number of steps)
- Sleep analysis
- Approx. 5 notifications per day
- Heart rate monitoring
- Automatic detection of activity (except running)
- Synchronization with the application
- Crown use
- Workout Mode launched from the watch menu without the Always on screen option, with GPS connected or not
- Automatic running detection
- Breathe feature
- Approximately 30 notifications per day
|- Quicklook feature on
- Display Always on during workout activated
|- Respiratory Scan|
The most energy-consuming features are not activated by default and are dedicated to more periodic use since they do not need to be activated continuously for the user, or in the interest of a medical follow-up. This is notably the case for the Respiratory Scan.
Recharging ScanWatch Light
When the battery level reaches 10%, you will receive a notification. At 10% you can no longer run a Respiratory Scan. When the battery reaches 0%, your watch activates power reserve mode. Only the analog clock, step, and sleep monitoring features remain available, and only for about 20 days. In power reserve mode you will no longer be able to start an ECG or oxygen saturation measurement on demand via the watch display.
You can easily recharge your ScanWatch Light by nestling the watch into the charger's cradle.
ScanWatch Light recharges to 80% in about 1 hour and to 100% in about 2 hours.