Use of the Body Scan's handle is required to take Segmental Body Composition and ECG measurements. The Wall Handle Mount is a handy piece of hardware that be easily attached to a wall to support the handle. It is intended to keep the handle accessible for measurements that require it. 

Important: The Wall Handle Mount is recommended for use on tiled walls only, as it may damage painted walls. 

To install the Wall Handle Mount, follow these steps:

1. In the Withings App, go to Devices > Body Scan.
2. Tap Wall Handle Mount.
3. Tap Next to follow the tutorial.
4. Remove the adhesive backing from the Wall Handle Mount.
5. Stick the mount to the wall approximately 1 meter (3 feet) from the floor.
   Note: Make sure there is some slack to the cable, as pictured below.
6. Place the cable holder on the scale - it will clasp the cable and free the handle for you to use.
   
   Proper Wall Mount Handle installation, highlighting the cable with adequate slack and cable holder installation on the scale.
7. The Withings App tutorial will ask "Did you install the Wall Handle Mount?" 
   Tap Yes to confirm that it has been installed. 

Note: When using the wall handle mount you should always use the cable stopper. When not using the wall handle mount you should not be using the cable stopper. This can cause accuracy issues for certain measurements.