choose language

Deutsch Français 日本語 简体中文

To deflate your Sleep, perform the following steps:

  1. Make sure to place the inner part of the Sleep out of its textile cover.
  2. Put the lower part towards you.
    A notch with the word Reset below indicates the location of the reset button.
  3. Unplug, then plug Sleep using the provided adapter.
  4. Press the reset button successively three times.
    A slight click indicates that the Sleep valve is open. The solid white LED lights up, the sensor should slightly deflate.
    Important: Keep the sensor plugged during the whole process. When the sensor is unplugged, the valve closes and prevents any air input/output of the Sleep. Note that the valve closes after 3 minutes.
  5. Remove the air from the sensor. Please refer to the picture below.
    deflate-nokia-sleep.png
  6. Unplug Sleep.
  7. Put the inner part of the device back into the textile cover.
    Make sure to flatten the sensor all over its surface in the textile cover.

Was this article helpful?

Didn't find what you need? Here's how to get in touch.

Contact us
To preserve the Withings Forum as a place of kindness, mutual support, and interest for the products and services provided by Withings, I am committed to:
  • Be courteous and participate in the community with a spirit of friendliness and understanding
  • Respect all users on the forum
  • Avoid controversy or quarrel
  • Ensure that my messages do not infringe on the rights, reputation, image, or privacy of others
  • Avoid any and all discussions which contain insulting or discriminatory comments
  • Abide by the full terms and conditions outlined here