Factory resetting your Sleep Analyzer allows you to delete all of the data stored on it.

Important note:

• Factory resetting your Sleep Analyzer will not remove any of the data that was synced from the Health Mate app.
• All data that wasn't synced before resetting your Sleep Analyzer will be lost permanently.
• Factory resetting your Sleep Analyzer deactivates the sleep apnea feature. To reactivate the sleep apnea feature, open the Health Mate app and go to Devices > Sleep Analyzer > Activate sleep apnea (Only available in the European Union).

To reset your Sleep Analyzer, perform the following steps:

1. Go to the Settings of your mobile device, select Bluetooth and locate Sleep Analyzer in the list of devices. Select the small icon to the right of the sleep sensor and select the option to Forget or Remove the device. 
2. Make sure to place the inner part of the Sleep Analyzer out of its textile cover.
   
3. Put the lower part of the device towards you.
   A notch with the word RESET below indicates the location of the reset button.
   
4. Unplug, then plug Sleep Analyzer using the provided adapter.
5. Press and hold the RESET button for five seconds.
   Note: Be sure to insert the paperclip (or a similarly-shaped object) into the hole just above the word RESET as the other opening on the Sleep Analyzer is for the sound sensor. Inserting an object into the sound sensor can damage it and prevent the breathing disturbance/apnea detection feature from working.
   
   The LED on the back of the device will flash red three times, then flash green continuously one time.
   
   
   A flashing blue LED indicates that the reset procedure has been done successfully.
   
6. Put the inner part back into the textile cover.
   Make sure to flatten the sensor all over its surface in the textile cover.
   

Click here if you want to install your Sleep Analyzer again.