choose language

Deutsch Français 日本語 简体中文

To assign a measurement on your BPM Connect, perform the following steps:

  1. At the end of the measurement, results are displayed on the screen of BPM Connect. Press the button to validate the measurement.
  2. Press the button again to select the user and attribute the measurement.
    By pressing the button once, you can cycle through the list of users to find your name. Repeat the process of pressing the button until you find your name and then press and hold the monitor's button to assign the measurement.
    Note: If your firmware version is still inferior to 1501, the process is a bit different. You need to press and hold the button to cycle through the users and click on the button to assign the measurement.


Was this article helpful?

Didn't find what you need? Here's how to get in touch.

Contact us
To preserve the Withings Forum as a place of kindness, mutual support, and interest for the products and services provided by Withings, I am committed to:
  • Be courteous and participate in the community with a spirit of friendliness and understanding
  • Respect all users on the forum
  • Avoid controversy or quarrel
  • Ensure that my messages do not infringe on the rights, reputation, image, or privacy of others
  • Avoid any and all discussions which contain insulting or discriminatory comments
  • Abide by the full terms and conditions outlined here

If you need assistance because of an issue which would not be resolved through troubleshooting, such as a product with physical damage, please contact our Support Team.