choose language

Deutsch Français 日本語 简体中文

Your ScanWatch can operate for up to 30 days on a single charge, depending on your use of the heart rate mode. To charge your ScanWatch, perform the following steps:

  1. Connect the USB end of the charging cable to a power source.
  2. Position the other end of the charging cable on the back of your ScanWatch in such a way that the magnets align.
    You can check the percentage of the battery on the display of the watch while it’s charging.



  • ScanWatch charger is the same for the 38mm and 42mm models.
  • The Steel HR charger cannot be used for ScanWatch.
  • Charging time is about 2 hours.
Was this article helpful?

Didn't find what you need? Here's how to get in touch.

Contact us
To preserve the Withings Forum as a place of kindness, mutual support, and interest for the products and services provided by Withings, I am committed to:
  • Be courteous and participate in the community with a spirit of friendliness and understanding
  • Respect all users on the forum
  • Avoid controversy or quarrel
  • Ensure that my messages do not infringe on the rights, reputation, image, or privacy of others
  • Avoid any and all discussions which contain insulting or discriminatory comments
  • Abide by the full terms and conditions outlined here

If you need assistance because of an issue which would not be resolved through troubleshooting, such as a product with physical damage, please contact our Support Team.