choose language

Deutsch Français 日本語 简体中文

Your ScanWatch can operate for up to 30 days on a single charge, depending on your use of the heart rate mode. To charge your ScanWatch, perform the following steps:

  1. Connect the USB end of the charging cable to a power source.
  2. Position the other end of the charging cable on the back of your ScanWatch in such a way that the magnets align.
    You can check the percentage of the battery on the display of the watch while it’s charging.
    scanwatch-charging.png

 

Note:

  • ScanWatch charger is the same for the 38mm and 42mm models.
  • The Steel HR charger cannot be used for ScanWatch.
  • Charging time is about 3 hours.
Was this article helpful?

Didn't find what you need? Here's how to get in touch.

Contact us
To preserve the Withings Forum as a place of kindness, mutual support, and interest for the products and services provided by Withings, I am committed to:
  • Be courteous and participate in the community with a spirit of friendliness and understanding
  • Respect all users on the forum
  • Avoid controversy or quarrel
  • Ensure that my messages do not infringe on the rights, reputation, image, or privacy of others
  • Avoid any and all discussions which contain insulting or discriminatory comments
  • Abide by the full terms and conditions outlined here

Note that this community is supported by its members, not the Withings Support Team.

If you need assistance because of an issue which would not be resolved through troubleshooting, such as a product with physical damage, please contact our Support Team.