言語を選ぶ

Deutsch English (US) Français 简体中文

To change the batteries of your BPM:

  1. Make sure the BPM is turned off.
    If the LED is on, press the button for 3 seconds.
  2. Use a coin to turn the battery cover counterclockwise and remove the cover. Push down as you turn the cap to the left. Turning the cap without pressing down will not allow it to open.
  3. Replace the batteries.
    Make sure the batteries are correctly inserted by following the polarity markings.
    Sens_des_piles.JPG
  4. Put the cover back in place.
    If the BPM does not power on, please check that the cover has been fully pushed back in place as you won't be able to switch it on if it is halfway through.
この記事は役に立ちましたか?

Didn't find what you need? Here's how to get in touch.

お問い合わせ
To preserve the Withings Forum as a place of kindness, mutual support, and interest for the products and services provided by Withings, I am committed to:
  • Be courteous and participate in the community with a spirit of friendliness and understanding
  • Respect all users on the forum
  • Avoid controversy or quarrel
  • Ensure that my messages do not infringe on the rights, reputation, image, or privacy of others
  • Avoid any and all discussions which contain insulting or discriminatory comments
  • Abide by the full terms and conditions outlined here

Note that this community is supported by its members, not the Withings Support Team.

If you need assistance because of an issue which would not be resolved through troubleshooting, such as a product with physical damage, please contact our Support Team.